Jeep Wrangler JK JKU 2011-2017 Carbon Fiber AC Control Panel Cover Trim - RT-TCZ Dashboard Accessory Kit (2pcs) | Premium Interior Upgrade for Off-Road & Daily Driving

looks good. Fits better than I thought it would.The lower piece will need a small modification.The hole for the 12 volt power port will need a small amount of material removed for clearance. It is located in the lower passenger side of the controls.You will need to remove a small amount of material in order to clear the hinge for the 12 volt port cover. You do not need to remove very much. I held the overlay on top of the port cover with the hole in the overlay ligned up with the round port cover.Draw two vertical lines on the overlay, directly up from the edges of the ports hinge. The lines need only go up to the highest point of the hole. Draw a horizontal line that connects the two vertical lines level with the top of the hole.The three lines are cut lines. I used a Dremel tool with cut off wheel to cut out the lines removing just enough material for the top of the hole to to be pushed past the hinge and then lowered into place so the rest of the hole will clear the port cover. The overlay will drop down into place and none of your cutting will be seen.Sounds complicated from the description but once you set the overlay in place it will become apparent what you need to do..Do the modification without removing the tape from the glue. Trim a little and dry fit the overlay until you get it the way you want it, then remove the tape and do the final installation..It's worth the mod to get a nice fit. The overlay really dresses up the JK's interior.